Mow It
Rules

Half the setting, twice the passes. The only way I spread anything.

How to use a lawn spreader without leaving stripes: set it to half of what the bag says, go back and forth, then go again side to side. Same amount of product, way better coverage. Plus what the spreader number means.

Set your spreader to about half of what the bag says. Go over the whole lawn back and forth. Then go over it again side to side. Same amount of product. No stripes. That’s it. That’s the post. You can go.

Still here? Fine. Here’s why it works.

Why one pass gives you stripes

You are not a robot. You drift. You speed up near the end. You misjudge where your last pass was. Spreaders don’t throw perfectly even either.

On one pass, every mistake shows up as a stripe. Light green where you missed, dark green or burned brown where you doubled up. Your neighbors will see it. They’ll say nothing. They’ll think about it a lot.

On two passes in two directions, the second pass covers the first pass’s mistakes. Misses get filled in, and since each pass is half strength, the overlaps don’t burn.

How I do it

  1. Fill the spreader on the driveway, not the grass. A spill on the lawn is a dead spot. A spill on the driveway gets swept up.
  2. Do the edges first. One lap around the outside of the lawn. Now you have room to turn around.
  3. Pass one at half the setting. Back and forth, like mowing.
  4. Pass two at half the setting, side to side across pass one.
  5. Close the hopper every time you stop or turn.
  6. Sweep the driveway and sidewalk back onto the lawn. Fertilizer on pavement just washes into the storm drain.

Plug in your bag and your lawn:

What the number on the bag means

That “6” or “3½” or “H” is the size of the opening, for one specific spreader, at a normal walking pace. It’s not a universal number. If your spreader isn’t on the bag, look up your spreader maker’s chart.

Also: half the number isn’t always exactly half the product. Spreaders aren’t that precise. That’s why I check after pass one. About half of what you need should be gone. Way more left? Bump it up a notch for pass two.

Things that make stripes anyway

The one-liner to remember

Half the setting, twice the passes. It takes 10 more minutes. It saves you a summer of looking at stripes you didn’t mean to make.

Need to know what’s in the bag in the first place? Here’s how to read a fertilizer bag. Need to know when to use it? Feed on the holidays.

Half Rate, Twice

Tell me what the bag says. I’ll tell you what to set and how much should be gone after each pass.

SET IT TO ABOUT 3

–Total
–Per pass
–Bags
–Left over

Edges first Pass 1 Pass 2

Your spreader

Spreader numbers aren’t perfectly even, so half the number isn’t always exactly half the stuff. So check yourself: after pass 1, about the “per pass” amount should be gone. Way more left than that? Bump it up a notch for pass 2. Your bag’s label wins.